Dell Precision T5820 RAM Upgrade

What Types of RAM Are Supported in the Dell Precision T5820?

• The Dell Precision T5820 supports RDIMM (Registered DIMMs) and UDIMM (Unbuffered DIMMs).

Which Memory Speeds Are Compatible With the Dell Precision T5820?

• The server supports DDR4-2133, DDR4-2400, DDR4-2666, DDR4-2933, DDR4-3200.
• Keep in mind that if different speeds are mixed, all modules operate at the slowest DIMM speed.

What Is the Maximum Supported RAM Capacity for the Dell Precision T5820?

• Up to 512GB (8 × 64GB) with RDIMMs.
• Up to 256GB (8 × 32GB) with UDIMMs.

How do I achieve the best performance for my Dell Precision T5820?

• Populate DIMMs evenly across all channels and use the highest supported speed compatible with your CPU.

What is RDIMM, UDIMM?

• RDIMM (Registered DIMM): Registered DIMMs are memory modules with an additional register between the memory controller and the DRAM. This register reduces the electrical load on the memory controller, allowing for better stability and scalability in servers. RDIMMs are commonly used in environments that require high reliability and performance.
• UDIMM (Unbuffered DIMM): Unbuffered DIMMs do not include a register or buffer, meaning they communicate directly with the memory controller. While they offer lower latency compared to RDIMMs and LRDIMMs, UDIMMs are typically used in desktops or workstations rather than servers, as they cannot support high memory capacities or intensive workloads.

General DIMM Population Guidelines for Dell Precision T5820

• Do Not Mix RDIMMs and UDIMMs
• If mixing memory speeds, all DIMMs will operate at the lowest speed.
• Install DIMMs starting furthest from the processor.
• Populate DIMMs evenly across all channels.
• Ensure all CPUs have memory installed for their DIMM slots to function.

Dell Precision T5820 Memory Installation Steps

• Power Off the server and disconnect it from power.
• Wear ESD Gear: Use an ESD wrist strap and work in an ESD-safe environment.
• Open the server and locate the DIMM slots.
• Inspect the slots for dust or debris and ensure proper alignment of the DIMMs.
• Follow the DIMM population order in the server manual.
• Firmly insert DIMMs until they click. Avoid using excessive force.
• Close the server and reconnect power.
• Verify the memory configuration in the BIOS.